Template:FAQ:Applications 02

From Net-SNMP Wiki
Revision as of 08:40, 28 May 2009 by Dts12 (Talk | contribs) (Latest FAQ revision - preparing for 5.5 release)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Adding a MIB to the client-side tools has two main effects:

  • it allows you to refer to MIB objects by name
    (rather than having to use the numeric OIDs)
  • it allows the results to be displayed in a more immediately meaningful fashion. Not just giving the object names, but also showing named enumeration values, and interpreting table indexes properly (particularly for string and OID index values).

There are two steps required to add a new MIB file to the tools. Firstly, copy the MIB file into the appropriate location:

       cp MY-MIB.txt /usr/local/share/snmp/mibs
           (which makes it available to everyone on the system)

or

       mkdir $HOME/.snmp
       mkdir $HOME/.snmp/mibs
       cp MY-MIB.txt $HOME/.snmp/mibs
           (which makes it available to you only)

Note that the location of the shared MIB directory may be different from that given here - see the FAQ entry "Where should I put my MIB files?" for more information.


Secondly, tell the tools to load this MIB:

       snmpwalk -m +MY-MIB ....
           (load it for this command only)

or

       export MIBS=+MY-MIB
           (load it for this session only)

or

       echo "mibs +MY-MIB" >> $HOME/.snmp/snmp.conf
           (load it every time)


Note that the value for this variable is the name of the MIB module, not the name of the MIB file. These are typically the same (apart from the .txt suffix), but if in doubt, check the contents of the file. The value to use is the token immediately before the word DEFINITIONS at the start of the file.

Or use the special value "all" to have the tools load all available MIBs (which may slow them down, particularly if you have a large number of MIB files).

Note that you need both steps.


Adding a MIB in this way does not mean that the agent will automatically return values from this MIB. The agent needs to be explicitly extended to support the new MIB objects, which typically involves writing new code.
See the AGENT section for details.

Most of the tools (apart from snmptable) will work quite happily without any MIB files at all - although the results won't be displayed in quite the same way. Similarly, the agent doesn't need MIB files either (other than to handle MIB object names in the configuration file).